Advertisement
Adjusting Fence
1.
Loosen (2) fence lock knobs shown in
Figure 19.
Lock Knobs
Figure 19. Location of fence lock knobs.
2.
Adjust fence to desired position, then tighten
fence lock knobs to secure.
Adjusting Flip-Stops
1.
Loosen flip-stop lock knob (see Figure 20).
2.
Pivot flip-stop to side of fence that workpiece
will contact, then adjust flip-stop position
along fence (see Figure 20).
Flip-Stop
Lock Knob
Flip-Stop
Figure 20. Flip-stop adjustment components.
3.
Tighten flip-stop lock knob to secure.
Model T32710 (Mfd. Since 08/21)
Fence
Operation Tips
To reduce risk of eye or face injury from
flying chips, always wear approved safety
glasses and a face shield when operating a
drill press.
• Periodically verify that the knob bolts used to
attach the Model T32710 to the drill press table
are snug.
• To avoid drilling in the table, make sure that the
drill press depth stop and drill bit alignment are
correct.
• Use the table only in dry environments.
• Wipe down workpieces to ensure they are free
of debris that may scratch the table.
• The table insert can be removed from the table
if you need to perform a through-drilling opera-
tion, but it will also minimize tear-out if left in
place.
Maintenance
• To avoid condensation and rust forming on
your drill press table, do not leave the Model
T32710 mounted on the drill press table for
long periods of time.
• Clean the Model T32710 by vacuuming out
T-slots when finished and wiping down table
and fence with any good household glass
cleaner.
-7-
Advertisement
