Table of Contents
Advertisement
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the switch disabling key disables the switch
properly.
Serious personal injury could occur from
connecting machine to power before
completing the setup process described in
this manual. DO NOT connect power until
instructed to do so later in this manual.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run the machine:
1.
Clear all setup tools away from machine.
2.
Connect machine to power supply.
3.
Turn machine ON, verify motor operation,
and then turn machine OFF.
The motor should run smoothly and without
unusual problems or noises.
4.
Remove switch disabling key, as shown in
Figure 28.
Model G0814/G0814X (Mfd. Since 04/22)
Figure 28. Removing key from paddle switch.
5.
Try to start machine with paddle switch.
Machine should not start.
— If machine does not start, switch dis-
abling feature is working as designed.
Congratulations! Test run is complete.
Proceed to Recommended Adjustments.
— If machine does start, immediately stop
machine. Switch disabling feature is not
working correctly. This safety feature must
work properly before proceeding with
operations. Call Tech Support for help.
Recommended
Adjustments
For your convenience, the adjustments listed
below have been performed at the factory and no
further setup is required to operate your machine.
However, because of the many variables involved
with shipping, we recommend that you at least
verify the following adjustments to ensure the best
possible results from your new machine.
Step-by-step instructions for these adjustments
can be found in SECTION 7: SERVICE.
Factory adjustments that should be verified:
1.
Knife/Insert Settings (Pages 41 & 43).
2.
Depth Scale Calibration (Page 45).
3.
Fence Stop Accuracy (Page 47).
4.
Table Parallelism (Page 50).
-25-
Advertisement
Table of Contents
