Table of Contents
Advertisement
Squaring Stock
Squaring stock involves four steps performed
in the order below:
1.
Surface Plane on Jointer—Concave face of
workpiece is surface planed flat with jointer.
2.
Surface Plane on a Thickness Planer—
Opposite face of workpiece is surface planed
flat with a thickness planer.
Previously Surface
Planed Face
Model G0814/G0814X (Mfd. Since 04/22)
3.
Edge Joint on Jointer—Concave edge of
workpiece is jointed flat with jointer.
4.
Rip Cut on a Table Saw—Jointed edge
of workpiece is placed against a table saw
fence and opposite edge cut off.
Previously
Jointed
Edge
-29-
Advertisement
Table of Contents
