Table of Contents
Advertisement
Adjusting Cams
The cams on the Model T32428 have two posi-
tions: UP and DOWN.
The UP position aligns the rollers with the surface
of the table saw table (see Figure 16). This posi-
tion cannot be used with fixtures in the miter slot
of the table, as these will contact the roller system
as the workpiece exits the outfeed side of the
machine.
Rollers Aligned with
Table Surface
Figure 16. Cams in UP position.
The DOWN position gives extra clearance to
allow for a miter gauge or other sliding fixture (see
Figure 17).
Rollers Slightly Below
Table Surface
Figure 17. Cams in DOWN position.
-14-
Loosen the cam lock knob on either side of the
roller system, move lock knobs to the position
indicated on the cam labels (see Figure 18), then
tighten the lock knobs.
Figure 18. Cam lock knob positions.
Model T32428 (Mfd. Since 11/21)
Advertisement
Table of Contents
