Sony DMX-R100 Operating Instructions Manual page 53

To assign or remove the channel to or from the group,
proceed as follows.
Setting the GANG fader group
1
Touch the desired group button.
Example: To set GP 1 to the GANG mode:
Touch the
GROUP 1
button.
2
Touch the mode button for the group selected in
step 1 until GANG appears on the mode button.
Display GANG.
3
Touch the channel button(s) that you wish to
assign to the GANG group.
Channel(s) already assigned to other GANG or
VCA groups must be unassigned before being
available for selection.
The group number appears on the channel button.
GP1 appears.
To remove the channel from the group, touch this
button(s) on which the group number is displayed.
The group number disappears and that channel is
removed from the group.
Setting the VCA fader group
Perform the following operation after step 1 described
in "Setting the GANG fader group".
2
Touch the mode button corresponding to the group
selected in step 1 until VCA appears on the mode
button.
3
Touch the channel button that you wish to assign
to the VCA group.
When there are channels that are not assigned to
the group, the fader of the channel that you
touched first becomes the master fader. GP1M is
displayed on the channel button assigned to the
master fader.
GP1M (Master fader of the VCA group 1)
To remove the channel(s) from the group, touch
this button(s) on which the group number is
displayed.
In the VCA group, if you touch the channel button
assigned to the master fader, the master fader
becomes a slave fader of the group, and the group
has no master fader. The fader which you touch
first after removing the former master fader
becomes the new master fader of the group.
53
Chapter 3 Menu