Audio Fader Grouping Window - Sony DMX-R100 Operating Instructions Manual

Menu Windows

AUDIO FADER GROUPING Window

To open this window, touch the AUDIO button on the
bottom menu bar, then select "FADER GROUPING."
This window allows you to set the fader group and cut
1 Group selection area
2 Mode button
3 ON/OFF button
4 Channel buttons
1 Group selection area
Touch the corresponding button to select the desired
group.
2 Mode button
Each time you touch this button, the button display
changes to GANG, VCA, or CUT, in order.
GANG: Keeps the relative level among faders when
touching faders on the unit.
VCA: When moving the fader assigned as the master
fader, the difference between the original level and the
current level is added to the level of the slave fader as
offset. Slave faders don't move when the master fader
is moved.
CUT: The cut switches of the channels belonging to
the corresponding group operate together.
The cut group is set independently from the fader
group.
Note
To select the mode of the group, remove all channels
from the group before attempting to select the mode.
52
Chapter 3 Menu
group for channels 1 to 48, the MTR busses, the AUX
send busses and the AUX return busses.
3 ON/OFF button
Selects whether the corresponding group is active.
4 Channel buttons
One channel can belong to one fader group and one cut
group. Channels cannot belong to multiple fader
groups or cut groups.
On the channel button, the upper number indicates the
fader group number and the lower number indicates the
cut group number.