Using The Automatic Isolate Function; Using The Write Hold Mode - Sony DMX-R100 Operating Instructions Manual

Using the Automatic Isolate Function

Using the Write Hold Mode

The automatic isolate function allows you to remove automation control
from selected channel or function. Using this automatic isolate function,
you can manually adjust the level, regardless of the stored automation data.
Even if the automation item is set to the isolate function, the control will
write automation data if dropped in.
This can be used as an automation mode, allowing you to stop previous
automation playback, finding a new setting of the control and dropping in.
1
Set the channel or function that has the item you want to adjust to
ISOLATE in the AUTOMATION window.
2
Set the item to be adjusted to READY.
3
Start the tape recorder to play, and adjust the sound signal to the proper
level.
Repeat level adjustments as required.
4
Rewind the tape and play it back.
5
Drop it at the proper point to set the desired item to WRITE.
6
Stop the tape recorder.
7
Clear ISOLATE of the automation item.
After WRITE HOLD mode is set, controls hold their adjusted position
even when the timecode is stopped. This function allows you to hold the
fader group.
You can readjust the level without previously stored automation data being
replayed when timecode is stopped.
1
Press the SAFE button to set it to ON (lit).
2
Set the READY button on the top menu bar to ON, open the OPTION
button menu and select the WRITE HOLD mode.
3
Select the FOOT SW button or AUTO button in the PUNCH IN/OUT
section in the AUTOMATION window.
Punch in/out is set.
4
Set the automation item to be adjusted to READY.
5
Start the tape recorder.
(Continued)
103
Chapter 4 Operation Tips