Download Print this page

Cisco 1600 Getting Started Manual page 43

Firepower management center
Hide thumbs Also See for 1600:

Advertisement

Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
IPMItool (Linux/Mac)
command
For a full list of LOM commands supported by the system, see the
Administration
Enable Lights-Out Management
You must be an Admin user to perform this procedure.
Before you begin
• Install an Intelligent Platform Management Interface (IMPI) utility on your local computer. See
• Determine which commands are needed to access an appliance using the IPMI tool. See
• Establish a connection from the CIMC port to a local network reachable from a computer where you will
• Disable Spanning Tree Protocol (STP) on any third-party switching equipment connected to the device's
Procedure
Step 1
In the management center web interface, choose System > Configuration, then click Console Configuration.
Step 2
For Console, choose Lights Out Management.
Step 3
Choose the address Configuration for the the system (DHCP or Manual).
Step 4
If you chose manual configuration, enter the necessary IPv4 settings:
• Enter the IP Address to be used for LOM.
• Enter the Netmask for the system.
• Enter the Default Gateway for the system.
ipmiutil (Windows)
command
Guide.
Utility Installation, on page 42
on page 42
for more information.
run the IPMI utility. See Step 8 of
on page 22
or , depending upon your version.
management interface.
The LOM IP address must be different from and in the same subnet as the management center
Note
management interface IP address.
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
Description
The command you want to issue to the
appliance. Note that where you issue the
command depends on the utility:
for more information.
Connect Cables Turn On Power Verify Status for Versions 6.3 - 6.4,
Enable Lights-Out Management
• For IPMItool, enter the command last:
ipmitool -I lanplus -H IP_address -U
username command
• For ipmiutil, enter the command first:
ipmiutil command -V4 -J3 -N
IP_address -U username -P password
Cisco Secure Firewall Management Center
LOM Commands,
IPMI
43

Advertisement

loading

This manual is also suitable for:

26004600