Advertisement
Perform Initial Setup at the Web Interface for Versions 6.5 and Later
Note
d) Click Next.
Once you click Next on the Change Password screen and the wizard has accepted the new admin
password, that password is in effect for both the web interface and CLI admin accounts even if you do
not complete the remaining wizard activities.
Step 4
At the User Agreement screen, read the EULA and click Accept to proceed.
If you click Decline the wizard logs you out of the management center.
Step 5
Click Next.
Step 6
At the Change Network Settings screen:
a) Enter a Fully Qualified Domain Name. If default value is shown, you may use that if it is compatible
with your network configuration. Otherwise, enter a fully qualified domain name (syntax
<hostname>.<domain>
b) Choose the boot protocol for the Configure IPv4 option, either Using DHCP or Using Static/Manual.
c) Accept the displayed value, if one is shown, for IPv4 Address or enter a new value. Use dotted decimal
form (for example, 192.168.45.45).
Note
d) Accept the displayed value, if one is shown, for Network Mask or enter a new value. Use dotted decimal
form (for example, 255.255.0.0).
Note
e) You can accept the displayed value, if one is shown, for Gateway or enter a new default gateway. Use
dotted decimal form (for example, 192.168.0.1).
Note
f) (Optional) For DNS Group you can accept the default value, Cisco Umbrella DNS.
To change the DNS settings, choose Custom DNS Servers from the drop-down list, and enter IPv4
addresses for the Primary DNS and Secondary DNS. If your management center does not have internet
access you cannot use a DNS outside of your local network. Configure no DNS Server by choosing
Custom DNS Servers from the drop-down list and leaving the Primary DNS and Secondary DNS fields
blank.
Note
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
14
On completion of the initial configuration process the system sets the passwords for the two
admin accounts (one for web access and the other for CLI access) to the same value. The
password must comply with the strong password requirements described in the
Firewall Management Center Administration Guide
for either admin account thereafter, they will no longer be the same, and the strong password
requirement can be removed from the web interface admin account.
) or hostname.
If you change the IP address during initial configuration, you need to reconnect to the
management center using the new network information.
If you change the network mask during initial configuration, you need to reconnect to the
management center using the new network information.
If you change the gateway address during initial configuration, you may need to reconnect to
the management center using the new network information.
If you use FQDNs rather than IP addresses to specify NTP servers, you must specify DNS at
this time. If you are using an evaluation license DNS is optional, but DNS is required to use
permanent licenses for your deployment.
Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
for your version. If you change the password
Cisco Secure
Advertisement
