Advertisement
Connect Cables Turn On Power Verify Status for Versions 6.5 and Later
• Connect a local computer to the management center serial port as described in Step 7. (To use this
connection see
• Connect the management center CIMC port to a local network reachable from a local computer where
you will run an IPMI utility for Lights-Out Management, as described in Step 8. (To use this connection
see
Set Up Lights-Out Management, on page
After rack-mounting the chassis, follow these steps to connect cables, turn on power, and verify connectivity.
Use the following figure to identify the rear panel ports.
Figure 4: Cable Connections
Before you begin
Important
Read the
chassis.
• Rack-mount the appliance as described in the
4600 Hardware Installation
Procedure
Step 1
eth0 management interface (labeled "1" on the rear panel) — Using an Ethernet cable, connect the eth0
interface to the default management network reachable from your management PC. This interface is the default
management interface and is enabled by default. Confirm that the link LED is on for both the network interface
on the local computer and the management center management interface.
You can use this connection to configure network settings and perform initial setup using HTTPS. You can
also use this connection to perform routine management, and to manage devices from the management center
web interface.
Step 2
(Optional) eth1 management interface (labeled "2" on the rear panel)—Connect this management interface
to the same or different network from your other management interfaces depending on your network needs.
For more information about management interfaces, see the
Administration Guide
Configuration
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
10
Set Up Serial Access, on page
Regulatory and Compliance Safety Information
Guide.
and about network topology, see the
Guide.
Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
40.)
41.)
document before installing the management center
Cisco Firepower Management Center 1600, 2600, and
Cisco Secure Firewall Management Center
Cisco Secure Firewall Management Center Device
Advertisement
