Advertisement
(Optional) Add Classic Licenses During Initial Setup (Versions 6.3 - 6.4)
Step 10
Read the End User License Agreement carefully; if you agree to abide by its provisions, then check the I
have read and agree to the End User License Agreement checkbox.
Step 11
Make sure that all the information you provided is correct, and click Apply.
The management center applies your configuration according to your selections, logs you into the web interface
as the admin user (which has the Administrator role), and displays the Summary Dashboard page.
Note
Step 12
If you connected directly to the appliance's management interface using an Ethernet cable, once you click
Apply you will be disconnected from the management center because its IP address has changed. Disconnect
the computer and connect the management center interface to the management network. To complete the
remaining procedures in the guide use a browser on a computer on the management network to access the
management center GUI at the IP address or host name that you just configured.
Step 13
Verify that the initial setup was successful by monitoring the Tasks tab in the Message Center.
What to do next
• Perform the activities described in
• Optionally, configure the management center for Serial or Lights-Out Management (LOM) access; see
(Optional) Add Classic Licenses During Initial Setup (Versions 6.3 - 6.4)
You use the management center to manage classic licenses for 7000 and 8000 Series, ASA with FirePOWER
Services, and NGIPSv.
Note
Before you begin
Before you add a classic license to the management center, make sure you have the Product Authorization
Key (PAK) provided by Cisco when you purchased the license. If you have a legacy, pre-Cisco license, contact
Cisco TAC.
Procedure
Step 1
Obtain the License Key for your chassis from the License Settings section on the Initial Setup page.
The License Key is clearly labeled (for example, 66:18:E7:6E:D9:93:35).
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
28
If your network environment uses NAT, the browser may time out attempting to reach the
management center using the address configured on the intial setup page. In this case, enter the
correct address in the browser address window and try again.
Set Up Alternate Management Center Access, on page
You must enable Classic Licenses on your managed devices before you can use licensed features. You can
enable a license during the initial setup of the management center (as described in the procedure below), when
you add a device to the management center, or by editing the device's general properties after you add the
device.
Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
Configure Management Center Administrative Settings, on page
40.
29.
Advertisement
