Advertisement
Review Automatic Initial Configuration for Versions 6.5 and Later
• If the settings are incorrect, enter n and press Enter. The system prompts for the information again,
Example:
Are these settings correct? (y/n) y
If your networking information has changed, you will need to reconnect.
Updated network configuration.
Step 8
After you have accepted the settings, you can enter exit to exit the management center CLI.
What to do next
• You can connect to the management center web interface using the network information you have just
• Review the weekly maintenance activites the management center configures automatically as a part of
• You can configure the management center for IPv6 addressing after completing the initial setup using
• You can optionally configure the management center for Serial over LAN or Lights-Out-Management
Review Automatic Initial Configuration for Versions 6.5 and Later
As a part of initial configuration (whether performed through the Initial Configuration Wizard or through the
CLI), the management center automatically configures maintenance tasks to keep your system up-to-date and
your data backed up.
These tasks are scheduled in UTC, which means that when they occur locally depends on the date and your
specific location. Also, because tasks are scheduled in UTC, they do not adjust for daylight saving time,
summer time, or any such seasonal adjustments that you may observe in your location. If you are affected,
scheduled tasks occur one hour "later" in the summer than in the winter, according to local time.
Note
• Weekly GeoDB Updates
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
18
beginning with hostname.
configured.
the initial configuration process. These activities are designed to keep your system up-to-date and your
data backed up. See
Review Automatic Initial Configuration for Versions 6.5 and Later, on page 18
the web interface as described in the
Guide
for your version.
access as described in
Set Up Alternate Management Center Access, on page
We strongly recommend you review the auto scheduled configurations, confirm that the management center
has established them successfully, and adjust them if necessary.
The management center automatically schedules GeoDB updates to occur each week at the same randomly
selected time. You can observe the status of this update using the web interface Message Center. You
can see the configuration for this automatic update in the web interface under System > Updates >
Geolocation Updates>Recurring Geolocation Updates. If the system fails to configure the update and
your management center has internet access, we recommend you configure regular GeoDB updates as
described in the
Cisco Secure Firewall Management Center Administration Guide
Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
Cisco Secure Firewall Management Center Device Configuration
.
40.
for your version.
Advertisement
