Advertisement
Management Center Initial Setup Using the Web Interface for Software Versions 6.3 - 6.4
• For the management center connected to a computer with an Ethernet cable, direct the browser on that
computer to the default management interface IPv4 address: https://192.168.45.45/.
• If you configured the management center IP address over a physical connection (see
Network Settings Using a Physical Connection for Software Versions 6.3 - 6.4, on page
computer on your management network to browse to the IP address of the management center interface.
Step 2
Log in using admin as the username and Admin123 as the password. (The password is case-sensitive.)
Step 3
In the Change Password section of the Setup page, change the password for the admin accounts. The admin
account for the web interface has Administrator privileges and cannot be deleted. We recommend that you
use a strong password that is at least eight alphanumeric characters of mixed case and includes at least one
numeric character. Avoid using words that appear in a dictionary.
Note
Step 4
The management center's network settings allow it to communicate on your management network. Configure
these settings in the Network Settings section of the Setup page:
• If you already configured the network settings for appliance access using a keyboard and monitor, the
Network Settings section of the Setup page may be prepopulated.
• If values are not prepopulated under Network Settings, or if you want to change the prepopulated values,
you must choose the management network protocol. The system provides a dual stack implementation
for both IPv4 and IPv6 management environments; you can specify IPv4, IPv6, or Both.
Depending on your protocol choice, the Setup page displays fields where you must enter the IPv4 or
IPv6 management IP address, netmask or prefix length, and default gateway for the management center.
You can also specify up to three DNS servers, as well as the host name and domain for the device.
• For IPv4, you must enter the address and netmask in dotted decimal form (for example, a netmask
• For IPv6 networks, check the Assign the IPv6 address using router autoconfiguration check box
Step 5
(Optional) In the Time Settings section of the Setup page you can set the time for a management center one
of two ways: either manually or using the network time protocol (NTP) from an NTP server.
• To set the time using network time protocol (NTP), select Via NTP from and specify one or more NTP
servers the management center can access.
• To set the time manually, select Manually and enter the current time in the provided fields.
To choose the time zone used on the local web interface for the admin account, click the current time zone
value and choose a time zone from the pop-up window.
Note
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
26
The admin accounts for accessing the management center through the shell as opposed to accessing
the management center using the web interface are not the same, and may use different passwords.
This setting changes both admin passwords to the same value.
of 255.255.0.0).
to automatically assign IPv6 network settings. Otherwise, you must set the address in colon-separated
hexadecimal form and the number of bits in the prefix (for example, a prefix length of 112).
Using an NTP server is critial to ensure proper time synchronization between the management center
and its managed devices. If you do not configure an NTP server during the initial setup process, we
strongly recommend you do so as soon as possible. See the Time and Time Synchronization section
in the
Cisco Secure Firewall Management Center Administration Guide
information.
Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
(Optional) Configure
25), use a
for your version for more
Advertisement
