Honeywell BC-200 Operation, Installation & Programming Manual page 59

Panel Operation
7.3.5.1.1 S
ERVICE
Once you have selected the AZF you wish to change you will be in the "Modify Point" screen as follows:
MODIFY POINT
DAY MODE
20 JULY 2002 14:44:37
PLEASE ENTER THE INFORMATION BELOW:
SELECTED POINT: 1.1.Z1
NAME. >
ZONE NO. >
POINT TYPE >
ALARMED? (Y/N) > Y
LATCHED? (Y/N) > Y
AVF? (Y/N) > N
TIMED? (Y/N) > N
Overwrite mode
The following data may be entered:
Item Description
NAME This is the descriptor for the AZF e.g. "LIFT MOTOR ROOM L16". Up to 28 characters are
allowed.
ZONE NUMBER This is the Zone number assignment of the AZF. One AZF per Zone. Allowed Zone
numbers are 1 to 999. An unnamed zone will prompt you for a zone name.
POINT TYPE Type of point: e.g. FIRE, HEAT, SMOKE, FLAME, FSW, MCP, VMD, PSW, SPR. This
information is purely for display purposes when in Fire Fighter's display mode.
ALARMED (Y/N) Determines if the AZF is to be a full alarm point or a non-alarm input used for logic purposes
only.
LATCHED (Y/N) Determines if the AZF is to be latching or non-latching type.
AVF (Y/N) Determines if the AZF is to utilise the Alarm Verification Facility. (See Appendix for
explanation of AVF)
TIMED (Y/N) Determines if the AZF is to be a time controlled input for use with Duct Probe detectors.
Refer Appendix for additional details).
Note: If the Selected Point already has data, the existing data will be displayed. This data may be modified by
overwriting, or can be confirmed by just pressing the ENTER button for the field (using the soft or hard
buttons, or the Enter on the keyboard).
Overwrite/Insert mode can be toggled by pressing the Insert key on the remote keyboard.
BC-200 Manual – P/N DOC-01-013
M – C
ENU ONFIG
A = 0
F = 0
I = 0
N = 1
Use arrows to move
around. INS,DEL to edit
lines. ENTER accept
line and/or Skip to
next item ESC to leave
this screen
ESC BACKSP ENTER
– AZF
Actions:
Use the external QWERTY keyboard to enter
descriptors
Press the ENTER button to move to the next line
Use soft YES and NO buttons as appropriate.
ESC will take you back to the previous screen
If a zone number other than zero is entered, you will
be prompted to enter a zone name. A previously
named zone will automatically display the zone
name.
Once all entries have been completed you will be
prompted to save changes (Yes/No). If you select
no, changes to the point will be ignored.
59