Casio DT-X100 Service Manual page 35

5. U-CASE-UNIT
* he following explains the procedure after the U-CASE-UNIT has been removed from DT-X100 (Refer to 2-2).
5-1. SPEAKER and ANT-UNIT
(1) Partially peel off the SP-CUSHION from the
HOLDER/SPEAKER.
(2)
Undo 2 #0 screws on both sides of the
SP-HOLDER and remove the HOLDER/
SPEAKER.
(3) Gently insert a thin precision fl at-bladed
screwdriver between the U-CASE and
SPEAKER, and remove the SPEAKER by
peeling it off .
(4) While raising the left end of the ANTENNA/
WLAN with your fi ngers, gently insert a thin
precision fl at-bladed screwdriver between the
ANTENNA/WLAN and UCASE, and remove
the ANTENNA/WLAN by peeling it off .
(5) Assemble the removed parts by reversing the disassembly procedure.
NOTE: To attach the ANTENNA/WLAN to the side of the U-CASE, fi rst orient the ANTENNA/WLAN so
that its adhesive side faces outward. (If the ANTENNA/WLAN is new, peel off the release paper,
beforehand.) Next, put the ANTENNA/WLAN fully in the groove of the U-CASE and attach it to the
side of the U-CASE. In this case, be sure that the ANTENNA/WLAN is fully put in and does not
protrude to the end surface of the case.
Insert into the place indicated with a dotted line.
HOLDER/SPEAKER
KEY/PW
ANT-UNIT cable: White
Insert here.
Raise here with your fingers.
Pass the antenna cable here.
— 32 —
Peel off.
ANTENNA/WLAN
CUSHION/SPEAKER
Insert here.
ANTENNA/WLAN