Casio DT-X100 Service Manual page 30

(3) Assemble the removed parts by reversing the disassembly procedure.
NOTE: Pay attention not to damage the CN5 springs
on the USB-UNIT-VA4.
NOTE: Once the USB-UNIT-VA4 is removed, its
adhesive force is weak. Therefore, use the
new one.
(For the new USB-UNIT-VA4, the USB-TAPE
is already attached.)
NOTE: After attaching the terminal section of the
USB-UNIT-VA4 to the L-CASE, put its cables
in the grooves of the L-CASE as shown.
NOTE: Put the cable in the concave part of
the L-CASE and fi x it to the L-CASE by
attaching the TAPE/CONNECTOR-B
to the position near the TRG-KEY. (On
both right and left sides)
USB-UNIT-VA4
Put in the grooves.
Attach the tape near the TRG-KEY.
Put the cable in the concave part.
— 27 —
W-TAPE/USB
TAPE/CONNECTOR-B