Table of Contents
Advertisement
52
www.aeg.com
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display prompts to set
the Language.
The display prompts to set
the Language.
The display shows F111.
The display shows an error
code that is not in this table.
Steam and condensation
settle on the food and in the
cavity of the oven.
The appliance does not re-
tain the water drawer after
you insert it.
Water comes out of the wa-
ter drawer after you carry it
or put it inside the appli-
ance.
Possible cause
The necessary settings are
not set.
The automatic switch-off is
activated.
The door is not closed cor-
rectly.
The fuse is blown.
The lamp is defective.
There was a power cut lon-
ger than 3 days.
The demo mode is activa-
ted.
The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
There is an electrical fault.
You left the dish in the oven
for too long.
You did not assemble the lid
of the water drawer correct-
ly.
You did not assemble the lid
of the water drawer correct-
ly.
Remedy
Make sure that the settings
are correct.
Refer to "Automatic switch-
off".
Fully close the door.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
Refer to "Before first use"
chapter.
Turn off demo mode in:
Menu / Basic Settings /
DEMO. Activation / deacti-
vation code: 2468.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Assemble the lid of the wa-
ter drawer correctly.
Assemble the lid of the wa-
ter drawer correctly.
Advertisement
Table of Contents
