Cisco Catalyst X4232 Installation And Configuration Note page 8

Front Panel Description
LEDs
Table 3 describes the LEDs on the Catalyst 4000 Layer 3 Services module.
Table 3
LED
STATUS
(module)
LINK
Port Number
G1 and G2
Port Number
3–34
1. Each port has an LED labeled with the port number associated with it. This is the link LED that indicates port
Connectors
Table 4 lists the front panel connectors on the Catalyst 4000 Layer 3 Services module.
Table 4
Port
Console
10/100MGT
10/100BASE-TX
1000BASE-X
Installation and Configuration Note for the Catalyst 4000 Layer 3 Services Module
8
LEDs on the Catalyst 4003 and 4006 Layer 3 Services Module
State
Green
Red
Orange
Green
Off
1
Green
Off
1
Green
Orange
Off
status
Front Panel Connectors on the Catalyst 4003 and 4006 Layer 3 Services Module
Description
This LED displays the results of a series of self-tests
and diagnostic tests performed by the switch.
All the tests pass.
A test other than an individual port test failed.
System boot, self-test diagnostics running, or the
module is disabled.
This LED displays the 10/100 management port status.
A signal is detected.
No signal is detected.
These LEDs display individual Gigabit Ethernet port
status.
A 1000-mbs link is detected.
No signal is detected.
These LEDs display individual 10/100 Ethernet port
status.
A 100-mbs link is detected.
A 10-mbs link is detected.
No signal is detected.
Connector
RJ-45
RJ-45
RJ-45
SC
78-10164-03