Cisco Catalyst X4232 Installation And Configuration Note page 48

Configuring the Module for InterVLAN Routing
VTP Transparent Mode
Configure the switch as VTP transparent to disable VTP on the switch. A VTP transparent switch does
not send VTP updates and does not act on VTP updates received from other switches. However, a VTP
transparent switch running VTP version 2 does forward received VTP advertisements out all of its trunk
links.
To disable VTP on the switch, perform these tasks in privileged mode:
Task
Step 1
Place the switch in VTP transparent mode
(disabling VTP on the switch).
Step 2
Verify the VTP configuration.
This example shows you how to configure the switch as VTP transparent and verify the configuration:
Console> (enable) set vtp mode transparent
VTP domain Lab_Net modified
Console> (enable) show vtp domain
Domain Name
-------------------------------- ------------ ----------- ----------- ----------
Lab_Net
Vlan-count Max-vlan-storage Config Revision Notifications
---------- ---------------- --------------- -------------
10
Last Updater
--------------- -------- -------- -------------------------
172.20.52.70
Console> (enable)
Setting the Layer 2 Port Speed
You can configure the port speed on 10/100 Ethernet ports. Use the auto keyword to have the port
autonegotiate speed and duplex mode with the neighboring port.
Make sure the device on the other end of the link is also configured for autonegotiation or
Caution
a port speed or duplex mismatch will result.
If the port speed is set to auto on a 10/100-Mbps Fast Ethernet port, both speed and duplex
Note
are autonegotiated.
To set the port speed for a 10/100-Mbps port, perform these tasks in privileged mode:
Task
Step 1
Set the port speed of a 10/100-Mbps Fast Ethernet
port.
Step 2
Verify that the speed of the port is configured
correctly.
Installation and Configuration Note for the Catalyst 4000 Layer 3 Services Module
48
Domain Index VTP Version Local Mode
1
1023 0
V2 Mode Pruning
disabled disabled 2-1000
Command
Console> (enable) set vtp mode transparent
Console> (enable) show vtp domain
2
enabled
PruneEligible on Vlans
Command
Console> (enable) set port speed
mod num/port num {10 | 100 | auto}
Console> (enable) show port
[mod_num[/port_num]]
Password
Transparent -
78-10164-03