Cisco Catalyst X4232 Installation And Configuration Note page 50

Configuring the Module for InterVLAN Routing
The default VLAN type is Ethernet; if you do not specify the VLAN type, the VLAN is
Note
an Ethernet VLAN.
This example shows you how to create an Ethernet VLAN and verify the configuration:
Console> (enable) set vlan 4 name Engineering
Vlan 4 configuration successful
Console> (enable) show vlan 4
VLAN Name
---- -------------------------------- --------- ------- ------------------------
4
VLAN Type
---- ----- ---------- ----- ------ ------ ------ ---- -------- ------ ------
4 enet
VLAN AREHops STEHops Backup CRF
---- ------- ------- ----------
Console> (enable)
To modify the VLAN parameters on an existing Ethernet VLAN, perform this task in privileged mode:
Task
Step 1 Modify an existing Ethernet VLAN.
Step 2 Verify the VLAN configuration.
Assigning Layer 2 Switch Ports to a VLAN
A VLAN created in a management domain remains unused until you assign one or more switch ports
to the VLAN. If you specify a VLAN that does not exist, the VLAN is created and the specified ports
are assigned to it.
To assign one or more switch ports to a VLAN, perform this task in privileged mode:
This example shows you how to assign switch ports to a VLAN and verify the assignment:
Task
Step 1
Assign one or more switch ports to a VLAN.
Step 2 Verify the port VLAN membership.
Console> (enable) set vlan 4 2/1
VLAN 4 modified.
VLAN 1 modified.
VLAN
---- -----------------------
4
Console> (enable) show vlan 4
VLAN Name
---- -------------------------------- --------- ------- ------------------------
4
VLAN Type
---- ----- ---------- ----- ------ ------ ------ ---- -------- ------ ------
Installation and Configuration Note for the Catalyst 4000 Layer 3 Services Module
50
Engineering
SAID MTU
100500 1500 -
Mod/Ports
2/1
Engineering
SAID MTU
Status IfIndex Mod/Ports, Vlans
active 344
Parent RingNo BrdgNo Stp
- - -
Command
set vlan vlan_num [name name] [state {active |
suspend}] [said said] [mtu mtu] [translation
vlan_num]
show vlan [vlan_num]
Command
set vlan vlan_num mod_num/port_num
show vlan [vlan_num]
show port [mod_num[/port_num]]
Status IfIndex Mod/Ports, Vlans
active 59
Parent RingNo BrdgNo Stp
BrdgMode Trans1 Trans2
- 0 0
2/1
BrdgMode Trans1 Trans2
78-10164-03