Cisco Catalyst X4232 Installation And Configuration Note page 63

To create a numbered extended IP ACL using abbreviations for both the source and destination, perform
the following task in global configuration mode:
Task
Define an extended IP ACL using an abbreviation
for a source and source wildcard of source 0.0.0.0,
and an abbreviation for a destination and
destination wildcard of destination 0.0.0.0.
Creating Named Standard IP ACLs
To create a named standard IP ACL, perform the following procedure, beginning in global configuration
mode:
Task
Step 1 Define a standard IP ACL, using an alphabetic
name.
Step 2 In access-list configuration mode, specify one or
more conditions that are to be permitted or denied.
This setting determines whether the packet is
passed or dropped.
Step 3 Exit access-list configuration mode.
78-10164-03
Command
Router (config) # access-list access-list-number
{deny | permit} protocol host source host
destination
Command
Router (config) # ip access-list standard name
Router (config) # deny {source [source-wildcard]
| any}
or
Router (config) # permit {source
[source-wildcard] | any}
Router (config) # exit
Installation and Configuration Note for the Catalyst 4000 Layer 3 Services Module
Configuring Access Control Lists
63