Table of Contents
Advertisement
Figure 8
Light out
of fiber
Attaching the 10/100 Interface Cables
For RJ-45 connectors, plug the interface cable connector into the receptacle on the module. Push in the
connector until you hear a click; the click indicates that the connector is fully inserted and secured in
the receptacle.
Accessing the Layer 3 Services Module for the First Time
This section explains how to access the Catalyst 4000 Layer 3 Services module, download an image to
bootflash, download an image from the network, and perform an image recovery using Xmodem or
Ymodem.
The Catalyst 4000 Layer 3 Services module is configured at the factory to automatically load a Cisco
IOS image (router operating system software) the first time you insert the module into a Catalyst 4000
family switch. The module software configuration register, which determines where the Catalyst 4000
Layer 3 Services module loads the image from, is set at the factory to load the IOS image from bootflash
(configuration register setting 0x2102). Table 9 shows the default configuration of the Catalyst 4000
Layer 3 Services module.
Table 9
Feature
Host name
Interface configuration
VLAN configuration
Password encryption
Break to console
1. You must configure VLAN 1 to be the default VLAN on both the Catalyst 4000 Layer 3 Services module and the Supervisor
78-10164-03
SC Type Connector
Keys
Light into
fiber
Key slots
Default Configuration of the Catalyst 4003 and 4006 Layer 3 Services Module
1
Engine
Installation and Configuration Note for the Catalyst 4000 Layer 3 Services Module
Accessing the Layer 3 Services Module for the First Time
Cable
Receptacle
Default Value
Router
None
None
Disabled
Ignore
27
Advertisement
Table of Contents
