Cisco Catalyst X4232 Installation And Configuration Note page 47

Task
Step 1 Define the VTP domain name.
Step 2
Place the switch in VTP server mode.
Step 3 (Optional) Set a password for the VTP domain.
Step 4 Verify the VTP configuration.
This example shows you how to configure the switch as a VTP server and verify the configuration:
Console> (enable) set vtp domain Lab_Network
VTP domain Lab_Network modified
Console> (enable) set vtp mode server
VTP domain Lab_Network modified
Console> (enable) show vtp domain
Domain Name
-------------------------------- ------------ ----------- ----------- ----------
Lab_Network
Vlan-count Max-vlan-storage Config Revision Notifications
---------- ---------------- --------------- -------------
10
Last Updater
--------------- -------- -------- -------------------------
172.20.52.70
Console> (enable)
VTP Client Mode
You cannot change the VLAN configuration on the switch when it is in VTP client mode. A switch in
client mode receives VTP updates from a VTP server in the management domain and modifies its
configuration accordingly.
To configure the switch as a VTP client, perform these tasks in privileged mode:
Task
Step 1 Define the VTP domain name.
Step 2 Place the switch in VTP client mode.
Step 3
Verify the VTP configuration.
This example shows you how to configure the switch as a VTP client and verify the configuration:
Console> (enable) set vtp domain Lab_Network
VTP domain Lab_Network modified
Console> (enable) set vtp mode client
VTP domain Lab_Network modified
Console> (enable) show vtp domain
Domain Name
-------------------------------- ------------ ----------- ----------- ----------
Lab_Network
Vlan-count Max-vlan-storage Config Revision Notifications
---------- ---------------- --------------- -------------
10
Last Updater
--------------- -------- -------- -------------------------
172.20.52.70
Console> (enable)
78-10164-03
Domain Index VTP Version Local Mode
1
1023 40
V2 Mode Pruning
disabled disabled 2-1000
Domain Index VTP Version Local Mode
1
1023 40
V2 Mode Pruning
disabled disabled 2-1000
Installation and Configuration Note for the Catalyst 4000 Layer 3 Services Module
Configuring the Module for InterVLAN Routing
Command
Console> (enable) set vtp domain name
Console> (enable) set vtp mode server
Console> (enable) set vtp passwd passwd
Console> (enable) show vtp domain
2
enabled
PruneEligible on Vlans
Command
Console> (enable) set vtp domain name
Console> (enable) set vtp mode client
Console> (enable) show vtp domain
2
enabled
PruneEligible on Vlans
Password
server -
Password
client -
47