Signalling Monitor; Unit Monitor - GE JungleMUX 86445-31 Technical Practice And Installation Manual

Cadence Type
Sets the type of ringing produced when in PLAR mode. May be set
to North American, European or Steady.
Note: This field is active only if PLAR is selected in the Signalling
Type field (see Signalling Setup window) and the unit's Micro code
is version 2.5 or later.
Ringing Duration
Sets the ringing duration when in PLAR mode. May be set to 10
sec, 20 sec, 60 sec and Indefinite.
Note: This field is active only if PLAR is selected in the Signalling
Type field (see Signalling Setup window) and the unit's Micro code
is version 2.5 or later.
Note: In the Loop Start (LS) and Ground Start (GS) signaling
modes the ringing duration is not limited.

Signalling Monitor

XMT Signalling
Shows current signaling status sent towards the far-end unit.
Note: When an Invalid signaling condition (i.e. combination of the
two signaling bits) is selected in the Transmit Signalling field (see
Test Setup frame), the unit will send the selected combination even
though it does not apply to any valid signaling condition for the
Signalling Type chosen.
Receive Signalling
Shows current signaling status received from the far-end unit
(unless overridden by the locally forced RCV Signalling test
condition in which case the forced condition is displayed).

Unit Monitor

Unit Status
Displays the current status of the unit. The possible readings are:
Temperature (unit temperature exceeds 93ºC) and OK.
Temperature
Displays the current temperature of the unit in ºC. An alarm is raised in
the Unit Status field if this reading exceeds 93ºC.
Copyright  GE Multilin Inc. 2002
342-86400-445PS
Issue 4.0
October 2006
Page 33