Honeywell Experion Orion Console Installation Manual page 28

Chapter 3 - Installing an Experion Orion Console
28
The work surface lift control has a lock. If only one bar is displayed in
the work surface lift control display, the lift columns for the work
surface are locked.
Figure 3-4: Work surface lift control display indicating that the lift
columns are locked
After 5 seconds of inactivity on the work surface lift control, the lift
columns lock.
To raise or lower the work surface
1. If the work surface display indicates that is locked, press and hold
the S button on the work surface lift control for one second.
Do not hold the S button longer than four seconds, otherwise the
lift columns will lock again.
When the height of the work surface appears in the work surface
lift control display, the lift columns are unlocked. Release the S
button.
2. Do one of the following:
To Do this
Raise Press and hold the up button. The work surface will
the rise, and the work surface lift control display will
work display the height of the work surface. Release the up
surface button when the work surface reaches the desired
height.
Lower Press and hold the down button. The work surface will
the lower, and the work surface lift control display will
work display the height of the work surface. Release the
surface down button when the work surface reaches the
desired height.
Next steps
You can store up to three work surface heights using the work surface
lift control.