Table of Contents
Advertisement
Chapter 3 - Installing an Experion Orion Console
24
4. Repeat for the other side of the console.
5. Remove the lower raceway cover.
To run the cable for the slat rail power bar
1. Depending on where you are located, complete one of the
following sets of instructions:
North American
Region
1. Unfasten the
power cable
located in the slat
wall cavity.
2. Pull the power
cable end through
the slat rail, into
the slat rail post,
and down into the
flexible cable
track.
3. Thread the cable
through the
flexible cable
track, and then
over and down
into the console
leg.
4. Pull the cable
across the lower
raceway to the
power strip.
5. Push the power
cable plug into the
power strip.
6. Repeat these steps
for the slat wall
power strip on the
other side of the
console.
Regions outside
Universal Power
North America
You will find a power
a. Pull the
cable in both energy
cable up
chains.
from the
flexible cable
a. Remove the slat
track and
into the slat
rail posts.
b. Pull the
cable across
from the slat
rail posts
b. Feed the power
and into the
slat wall
cavity.
c. Push the
power cable
c. Plug the power
plug into the
power strip.
d. Repeat these
steps for the
slat wall
power cable
on the other
side of the
console.
rail post covers
and pull the power
cable ends up
through the cage
opening on both
sides.
cable ends into the
slat rail electrical
housing on both
sides.
cables into the two
power bars located
in the slat rail
electrical housing.
Hide quick links:
Advertisement
Table of Contents
