Getting Started With The Configtool; Installing The Configtool Ip Utility; Discovering Your Device On The Network - Honeywell Performance Series User Manual

Getting Started with the ConfigTool

This chapter contains the following sections:
•
•
•
•
•

Installing the ConfigTool IP Utility

Before you can start using your camera, you must install the ConfigTool IP utility on your PC.
1.
2.
3.
4.
5.
6.

Discovering Your Device on the Network

Use ConfigTool to discover your IP device(s) on the network. To discover your device(s), open
ConfigTool. All of the connected IP devices on the network are listed. To refresh the list, click
Refresh.
Installing the ConfigTool IP Utility, page 15
Discovering Your Device on the Network, page 15
Assigning a New IP Address to Your Device, page 16
Upgrading the Device's Firmware, page 17
Opening a Web Client, page 18
Note There are two IP config tools available for your use: Honeywell ConfigTool and
Honeywell IPC Tool. To use the Honeywell ConfigTool, refer to the steps below.
To use the Honeywell IPC Tool, refer to the guide contained on the CD.
Insert the software CD that came with your camera into your PC's disk drive.
Open the Honeywell Config Tool folder, and then double-click Honeywell
ConfigTool.exe.
Click Next on the ConfigTool welcome screen.
Read the User License Agreement. If you agree, select I agree.
If you want, you can change the installation directory (by default, ConfigTool will be
installed in C:\Program Files). To proceed with the installation, click Install.
If the installation is successful, the message Installation is complete! appears.
Click Enjoy Now to open ConfigTool.
1
1
800-23288 - A - 07/2017