Honeywell Galaxy Dimension Series Installer Manual page 46

Audio Control (cont'd)
Addressing
The AudioInterface has a fixed module address.
Mounting
the Audio Interface Module can be mounted in two ways:
• above the control panel PCB using a specially designed mounting plate.
• inside a standard RIO box separate from the control panel.
Connecting the Audio Interface Module to the PSTN
The Audio Interface Module must be connected to the Galaxy panel PCB as in the following diagram.
Incoming
PSTN Line
Connecting Microphones and Speakers
The Audio channels can work with most line-level audio equipment. Microphones must have a pre-amplifier
that delivers audio or can deliver audio at line level (3V peak to peak). The audio card can transmit audio to
speakers with their own amplifier which accepts line level signals. Please see any instructions with the Micro-
phone device regarding the adjustment of sensitivity. The Galaxy Audio system can be used with the following
Honeywell audio devices:
TP800/TP2-800GY:
IS215TCE-MIC:
DT7450-MIC:
TP800/TP2-800GY Connection
The following table details the terminal connections
of the TP800 speaker unit to the Audio Interface:
Audio Interface TP800/TP2-800GY
GND
+4.5V
CMD
SPK
MIC
TMP
Table 3-8. TP800/TP2-800GY
Connections to Audio Interface
Galaxy Panel PCB
LINE PHONE
B A B A
Figure 3-7. Audio Interface connected to PSTN
Speaker and Microphone unit
PIR detector with built-in microphone
Dual Tech detector with built-in microphone
VS-
VS+
Link AP to VS-
CMD
to complete
RML
tamper circuit
ECOUT
AP
AP
Galaxy Dimension Installer Manual
Audio Interface PCB
30 metres maximum from
panel to Audio Interface
Extension Phone
IS215TCE-MIC/DT7450-MIC
Connection
Audio Interface
Table 3-9. Detector Connections to
3-14
IS215TCE-MIC/DT7450-
MIC
GND
12V
MIC M
GRD G
Audio Interface
-
+