Honeywell Galaxy Dimension Series Installer Manual page 115

Galaxy Dimension Installer Manual
45.4 = Timers
This option allows each of the programmed weekly timer schedules to be switched on and off as required. If a
timer schedule is set to off, the operation of the timer is suspended; this option cannot be used to alter the
programmed times. All timer schedules default to 0 = Off. To switch the timer schedule on, select the required
timer and change the setting to 1 =On.
The Timer Status can also be altered through menu option 65.1 by the engineer only.
On selecting the option, the early opening status of the groups is displayed; early opening enabled is indicated
by a Y below the group; an N is displayed below the groups that are not programmed to open early. All
groups default to N.
NOTE: Only the engineer can enable early opening for individual groups, but global enable must be done
first.
45.5 = Late Work
The Late Work option — if programmed as 1 = Enabled — authorizes an Autoset Extension in advance
of the prewarning period (refer to option 65.3 = TIMERS.Autoset);
NOTE: Additional extensions can be authorized by entry of a valid code during the subsequent autoset
prewarning periods.
45.6 = Weekend Work
The Weekend Work option allows a valid user code to authorize the system to unset at the weekend. There
are two options:
1 = Program Days
This option allows the weekend day option to be selected.
1 = Weekend Day
On selecting this option the programmed Weekend Day is displayed; the default is 0 = OFF. Use the A or B
keys to select the required day or days and press the ent key to accept the programming and return to the
previous menu level:
0 = OFF
1 = SAT
2 = SUN
3 = BOTH (Saturday and Sunday)
The selected Weekend Day remains active for one occurrence only. The Weekend Day returns to the
default of OFF immediately following the assigned day. The Weekend Day must be allocated each time the
function is required.
If the Weekend Day is programmed other than 0 = OFF (default), on the next occurrence of the pro-
grammed Weekend Day, the Timers adopt the times assigned in Pattern day from option 65.1.6. For
example, this allows a Sunday to use the Autoset and Lockout Timers from Monday to Friday.
NOTE: Parameter 51.41 = Weekend Work must be enabled (default is Disabled) to allow the Weekend
Day to be selected by the user.
45 - Timer Control (cont'd)
6-41