Honeywell ACM 150 Manual To Installation, Operation, And Maintenance page 9

ACM 150
Trained technician
This icon identifies Trained Technicians. Definition of a Trained Technician:
• A Honeywell Analytics employee who is a service technician, chemist or engineer.
• An employee of the user's company or a third party service company who is a
service technician or engineer and who has received training from Honeywell
Analytics or its agent on the operation and service of the ACM 150 monitor and
who is authorized by his/her company to perform this service.
• A Honeywell Analytics agent who is a service technician or engineer and who has
also received training from Honeywell Analytics on the operation and service of
the ACM 150 monitor.
Personnel not included in one of these categories are not authorized service
technicians. On an emergency basis, an operator who is not trained as an authorized
technician may be asked to open the doors of the ACM 150 monitor, observe
operations and report to a trained technician at Honeywell Analytics (or its agent
company). Corrective actions may be recommended based on those observations.
Danger
Electrocution can occur when dealing with electrical circuits. Under no
circumstances shall an untrained person be permitted to access, test, touch or
remove any electrical circuits, plates or shields in the ACM 150 monitor. Refer
to Lockout / Tagout Procedure
danger
L'électrocution peut se produire lorsqu'ils traitent avec des circuits électriques. En
aucun circonstances sont une personne non formée autorisés d'accès, de test, tactile
ou supprimer tous les circuits électriques , plaques ou de boucliers dans le moniteur
ACM 150 . Référer à verrouillage / Procédure Tagout avant de réparer le moniteur ACM
150 .
Risk analysis
The use of The ACM 150 Air Composition Monitor entails inherent safety risks.
Hazards include fluidics hazards, chemical hazards, physical hazards and electrical
hazards. Fluidics hazards come from pressurized sample and air lines. Chemical
hazards include the hazards associated with the air sample and the hazards related
to the various components within the monitor. Physical hazards involve maintenance
or removal of some heavy components inside the monitor. Electrical hazards include
the high voltage (110/220 VAC) located within ACM 150 enclosure.
before servicing the ACM 150 monitor.
9