Getting Started; Connecting External Devices - Honeywell 30 Series User Manual

2 Getting Started

This chapter contains the following sections:
•

Connecting External Devices

•
Starting and Shutting Down the NVR
•
Device Initialization
Connecting External Devices
• Connect the cameras
Connect the RJ45 network cables from the cameras to PoE ports.
• Connect the monitor
Connect a VGA cable (not supplied) to the VGA interface and/or an HDMI cable (not supplied)
to the HDMI interface. Connect the other end to a monitor (do not use a TV). Simultaneous
VGA and HDMI output is supported.
• Connect the mouse
Connect the supplied USB mouse to the USB port.
• Connect the Ethernet cable
Connect the supplied CAT5e Ethernet cable to the network port. Connect the other end to a
router on your network.
• Connect audio devices (if applicable)
To record audio, connect the audio sources to the AUDIO IN connectors. To play audio,
connect an audio output device (low-impedance headphones, speaker, or amplifier) to the
AUDIO OUT connector (200 mV / 1 kilohm).
• Connect alarm devices (if applicable)
Connect alarm devices to the alarm in/out interface. If the alarm inputs use external power,
the device must have the same ground as the NVR.
• Connect a PTZ camera (if applicable)
Your embedded NVR communicates with PTZ cameras through the Network. Ensure that your
camera is correctly connected to the Network.
• Connect the power cable
Use only with the supplied power cable. Power output: 120W for 8 channels / 200W for 16
channels. PoE 802.3at in total. Use of an uninterruptible power supply (UPS) is strongly
recommended.
on page 5.
on page 6.
on page 7.
Getting Started
5