Verify; Settings-Network-Ip - Honeywell 30 Series User Manual

Status: S.M.A.R.T. status polled from the disk drive. This is not the results from a manually-
executed S.M.A.R.T. test.
Attribute name: The various attributes can vary from different HDD manufacturers. Value:
Value for the currently selected attribute.
Worst: Worst value acquired for that attribute.
Threshold: A predefined threshold or triggering value. The threshold below which the
normalized value will be considered exceeding specifications.
Raw value: The detected parameters for that attribute.
Status: The judgement made to deem the current reading as OK or failed.

Verify

Click Verify on
initiated through this button.
Bad block: Performs read/write test to drive sectors to locate bad blocks. This action may take
several hours to complete.
Fast S.M.A.R.T.: Tests the electronic and mechanical performance and disk read performance,
including those on disk buffer, read head, seek time, and integrity of drive sectors. The short
test is performed on a small section of disk platters, and takes about 2 minutes to complete.
S.M.A.R.T.: The long test is more thoroughly and is performed to all drive sectors. The actual
completion time depends on drive sizes and the attributes put to test.
The Check disk functions mentioned above, when performed during active I/Os, can consume
system resources and cause dropped frames with the recording tasks.
Disk verify function requires a volume to be temporarily
Note disabled; namely, the video recording will be stopped before disk
verify can be performed.

Settings-Network-IP

Go to 
Figure 6-42 to check the disk status. Three types of check disk actions can be
IP.
Settings
57