Attach Front Door To Chassis - Cisco 8800 Series Hardware Installation Manual

Attach Front Door to Chassis

Figure 30: Top Hood for 8808 Chassis
Step 9
Secure the top hood with the cable management brackets by using four M4 x 6 mm pan-head Phillips screws.
Tighten each screw to 11.5 to 15 in-lb (1.3 to 1.7 N·m) of torque.
Attach Front Door to Chassis
Before you begin
Before you can attach the front door to the chassis, you must attach the cable management brackets, bottom
plate, and top hood onto the chassis.
Procedure
Step 1
On the back side (open side) of one door, pull in on two protruding spring pins so that the pins are held inside
the door frame.
Hardware Installation Guide for Cisco 8800 Series Routers
44
Unpack and Install the Chassis