Powering on the Router
Caution
To ensure that power remains off while you are performing this procedure, lock-out/tag-out the DC circuit
breaker switch in the off (0) position until you are ready to turn it on.
Follow these steps to connect the DC source power cables to a DC power tray:
Procedure
Step 1
Verify that the power tray switch is set to the STANDBY (0) position.
Figure 36: DC Power Tray
1
Step 2
Remove the clear plastic safety covers that fit over the DC power connection terminal studs.
Rear
Connect DC Power Supply to Power Source
2
Front
Hardware Installation Guide for Cisco 8800 Series Routers
51