Honeywell Notifier NFS2-640/E Programming Manual page 89

How to Program a Releasing Zone
INSTANT RELE
NOTE: An output with an
selection (a releasing zone may be used, but is not required); an output circuit mapped to the
same zone; Switch Inhibit selected; Non-Silenceable; No Walk Test.
The following contains information needed to program an Instant Release circuit for an output
circuit (control module or NAC)
Description

An output circuit programmed to activate non-releasing devices, such as door openers or warning
sounders, without counting down delay timers. A device programmed with the
Code device is supervised for open circuits and ground faults.
Programming

1. Select a control module or a NAC (refer to"Modify or Delete a Point (2=point)" on page 19) to
use as a Releasing Circuit.
2. Select the
shown).
3. Select the Releasing Zone (R0-R9) for your releasing application.
4. Press the
Example

A programming example of a control module programmed as an Instant Release circuit for
Releasing Zone R5.
Figure A.19 Control Module Configured as an Instant Release Circuit
NFS2-640/E Programming Manual — P/N 52742:L2 7/17/14
Type Code
INSTANT RELE
.
Type Code, as shown in the following example (control module
INSTANT RELE
P R O G R M I N S T A N T R E L E M O D U L E A D D R 2 M 1 0 1
Releasing Zone
selection (R5 shown)
key to save, then press the
ENTER
Monitor
Detector
Module
Type Code
INSTANT RELE
Control
B01
Module
For example, a control module programmed with the
Type Code activates simultaneously with
INSTANT RELE
other outputs programmed for R05 (B01 and B02).
Type Code requires the following selections: a zone
Type Code selection:
INSTANT REL
R 5 _ _ _ _ _ _ _ _
Switch Inhibit: I = selected
key two times to return to the Program Change screen.
ESC
Detector
R05
B02
Releasing Applications
Type
INSTANT RELE
I * * 2 M 1 0 1
Walk Test
Selection: * = off
Silenceable: * = off
Detector
Type Code
INSTANT RELE
Control
Module
89