Honeywell Notifier NFS2-640/E Programming Manual page 83

How to Program a Releasing Zone
RELEASE CKT
NOTE: A Release Circuit with this Type Code requires the following selections: A Releasing
Zone selection (R0-R9); An output circuit mapped to the same Releasing Zone; Switch Inhibit
selected; Non-Silenceable; No Walk Test.
NOTE: Do not use a Release Circuit for the following: An application requiring ULC Listing; An
application requiring power-limited energy cable.
The following contains information needed to program a Release Circuit for an output circuit
(control module or NAC)
Description

A control module or a NAC used to activate a releasing solenoid or other releasing device. You can
also program multiple outputs with the
the Releasing Zone activates, all outputs associated with the releasing zone and with the
Type Code also activate at the same time. A Release Circuit activates when:
CKT
• An initiating device programmed to the same Releasing Zone activates (two devices if using
the Cross Zone option)
• The Delay Timer for R0-R9 (if used) expires
• The Abort Switch for R0-R9 (if used) is not active
Programming

1. Select a control module or a NAC (refer to "Modify or Delete a Point (2=point)" on page 19)
to use as a Release Circuit.
2. Select the
shown).
3. Select the Releasing Zone (R0-R9) for your releasing application.
4. Press the
screen.
NFS2-640/E Programming Manual — P/N 52742:L2 7/17/14
Type Code
.
RELEASE CKT
Type Code, as shown in the following example (control module
RELEASE CKT
P R O G R M R E L E A S E C K T
R 5 _ _ _ _ _ _ _ _
Releasing Zone
selection (R5 shown)
Switch Inhibit: I = selected
key to save, then press the
ENTER
Type Code to the same Releasing Zone. When
Type Code selection:
RELEASE CKT
M O D U L E A D D R 2 M 1 0 8
I * *
Silenceable: * = off
key two times to return to the Program Change
ESC
Releasing Applications
RELEASE
2 M 1 0 8
Walk Test
Selection: * = off
83