Wiring Diagram - Makita DUR361U Technical Information

W
iring diagram
Fig. D-2
Wiring in Housing (L) before setting Terminals and Adapter circuit complete
10-Pin connector
Rib A
Fuse
Put Fuse here,
if it is used.
3-Pin connector to connect
with Power supply cord unit
3-Pin connector to connect
with Adapter circuit complete
Put Controller's lead wires
connected to 9-Pin connector
between Rib B and Rib C.
3-Pin connector to connect
with Power supply cord unit
Connect 9-Pin connector of
Controller to that of Stator, then
put them on 3-Pin connector
of Power supply cord unit.
Put the following Controller's lead wires between Controller and Rib A.
* Lead wires to Stator
* Lead wires to Power supply cord unit
Rib B
Rib D
Aligning the end of Power supply cord to Rib D,
fix the cord with Cord clamp.
Note: Be careful not to clamp Tube with Cord clamp.
Sub Controller
Controller
Rib C
Power supply cord unit
Cord clamp Tube
Controller
Power supply cord unit
P 14/ 16
9-Pin connector
9-Pin connector