Makita DUR361U Technical Information page 3

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Shaft pipe complete
DISASSEMBLING
(1) Remove Clamp washer complete, Blade and Receive washer. (Fig. 2)
Fig. 2
1. While inserting Hex wrench 4 into the hole of Gear case
assembly to stop Cutter shaft revolving, turn M8 Hex nut
clockwise to remove Blade.
Hex wrench 4
Gear case
assembly
(2) Remove Gear case assembly. (Fig. 3)
Fig. 3
1. Loosen two M5x20 Hex socket head bolts, then unscrew M5x16
Hex socket head bolt, and then remove Protector and Protector clamp.
Note: Because M5x20 Hex socket head bolts with Polypropylene
washers 4 is drop-proofness, it is not necessary to entirely
remove from Protector clamp.
Protector clamp
M5x16 Hex
socket head bolt
M5x20 Hex socket head bolt
with Polypropylene washer 4
Protector
2. Remove Clamp washer complete,
Blade and Receive washer.
Clamp washer complete
M8 Hex nut
Receive
washer
2. Loosen M5x25 Hex socket
head bolt, then pull off Gear
case assembly.
M5x25 Hex socket
head bolt
Gear case assembly
P 3/ 16
Blade