Wiring Diagram - Makita UH520D Technical Information

W
iring diagram
Fig. D-3
Red dot mark
Connect Lead wire (red) to the
connecting terminal near
Red dot mark.
Fig. D-4
Face black Lead wire to Controller side
and set DC motor to Motor housing L.
Pass Controller's Lead wires (6 pcs.)
between Rib A and Rib B to prevent
them from being put on the Ribs.
Wiring to DC motor
Connectors
Wiring in Motor housing L
Line filter
Put Line filter in this
position if it is used.
Rib A
Rib B
Tape for
bundling
Lead wires
Controller
Face Lead wires (red, black) to Motor housing L
side and connect their connectors with Terminals
of DC motor.
Controller side
Lead wire (black)
Lead wire (red)
Motor housing L side
Bearing box
Lead wire (red) between Controller
and DC motor has to be routed between
Boss and inner wall of Motor housing L.
Boss
DC motor
P 12/ 13
Motor housing L
Bearing box