Makita DUR361U Technical Information page 4

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Shaft pipe complete (cont.)
DISASSEMBLING
(3) Remove Handle section, and pull off Shaft pipe complete. (Fig. 4)
Fig. 4
1. Remove Handle holder by unscrewing
two M5x30 Hex socket head bolts.
M5x30 Hex socket
head bolt (2 pcs.)
Handle holder
4. Remove Main grip set (R) from
Main grip set (L).
Main grip set (L)
6. Pull out Power supply cord unit through Cushion.
Power supply cord unit
Cushion
2. Unscrew M5x35 Pan head screw,
then pull off Handle complete
from Main grip set.
Handle complete
Main grip set
5. Remove Cord clamp by unscrewing 4x18 Tapping
Main grip set (L)
Main grip set (R)
7. Pull off Shaft pipe complete by removing M5x20
Note: If it is difficult to remove by hand, pull off
Rag to prevent the shaft
from damaging
Shaft pipe complete
3. Unscrew five 4x18 Tapping
M5x35 Pan head screw
screw, separate electrical parts (Receptacles, Main
switch, Closed end splice) from Main grip set (L).
Main Switch
Hex socket head bolt and M5x16 Pan head screw.
the pipe by gripping it with water pump pliers.
Shaft
Water pump pliers
M5x16 Pan head screw
P 4/ 16
screws to disassemble Main
grip set.
4x18 Tapping screw
(5 pcs.)
Cord clamp
4x18
Tapping screw
Receptacles
M5x20 Hex socket
head bolt