Oral-B TRIUMTH 5000 Manual page 12

• The flashing green lights indicate that the tooth-
brush is charging (picture 1, page 5); once it is
fully charged, the lights turn off. A full charge
enables up to 10 days of regular brushing (twice
a day, 2 minutes).
Note: If the green lights do not flash immediately,
continue charging. They will appear in 10–15
minutes.
• If the rechargeable battery is low the red low
charge indicator light is flashing for some sec-
onds when turning your toothbrush on/off. If the
rechargeable battery is empty the motor will stop;
it will need a 40-minute charge before you can
use it for a 2-minute brushing.
• You can check the charging status for some
seconds by turning your toothbrush on/off or
placing it on the charging unit.
SmartGuide adjustments
The SmartGuide (i) comes with a demonstration
mode activated. Deactivate this mode by removing
the battery compartment cover in the back
(picture A, page 4) and push the «set» or «h/min»
button. A flashing «12:00» indicates that you can
now adjust the clock time.
Clock Time
Press and hold the «set» button until «12h» is
displayed. By briefly pressing the «h/min» button,
you can toggle between «12h» or «24h» daytime
format. Push «set» to confirm your choice. Then
the hour digit starts flashing. Press the «h/min»
button until the right hour appears and confirm with
«set». Proceed same way to set both minute digits
(picture B, page 4). If you prefer not using the clock
feature, the flashing «12:00» will disappear auto-
matically after 24h.
SmartGuide Icons
Displayed Meaning
Icon
«Daily Clean» mode
«Deep Clean» mode
«Sensitive» mode
«Polish» mode
«Massage» mode
Too much pressure is applied.
Reduce the brushing force.
«Quadrant circle»
Move to the next quadrant of your
mouth when the relevant segment
flashes.
You reached the dentist recom-
mended 2-minute brushing time
(3-minute brushing time within the
Deep Clean mode).
You will receive a star with each
completed quadrant.
Smart Guide Batteries are low.
Change batteries of the SmartGuide.
Using your toothbrush
Brushing technique
Wet brush head and apply toothpaste; you can use
any kind of toothpaste. To avoid splashing, guide
the brush head to your teeth before switching the
appliance on.
When brushing your teeth with one of our rotating
brush heads (find out more in chapter Brush heads,
page 14), guide the brush head slowly from tooth
to tooth, spending a few seconds on each tooth
surface (picture 3, page 5).
When using our TriZone brush heads (find out more
in chapter Brush heads, page 14) place the tooth-
brush bristles against the teeth at a slight angle
towards the gumline. Apply light pressure and start
13