Monitoring Menu - Honeywell HVAC232 Series Applications Manual

8.3

Monitoring menu

RE ADY RU N S TOP ALARM FAULT
RE F
M ON
PAR
SYS
F W D R E V I O / K E Y P A D B U S
OK
Press OK to enter
1
Monitring menu
RE ADY RU N S TOP ALARM FAULT
RE F
M ON
PAR
SYS
FWD R EV I/O K EYPAD BUS
Press Down to browse V4.5
3
RE ADY RU N S TOP ALARM FAULT
RE F
M ON
PAR
SYS
FWD R EV I/O K EYPAD BUS
Fig. 40. Monitoring menu display
Application manual HVAC232/402 | Document 27-652 | Issue ENG06 | 2019-08-07
RE ADY RU N S TOP ALARM FAULT
RE F
M ON
PAR
SYS
F W D R E V I O / K E Y P A D B U S
Press Left/Right to browse
2
other Monitoring groups
RE ADY RU N S TOP ALARM FAULT
RE F
M ON
PAR
SYS
FWD R EV I/O K EY PAD BUS
OK
Press OK and the value
4
is displayed
Press OK.
5
OK
V4.5 is displayed
Monitoring values are actual values of measured signals as well as status of
some control settings. It is visible in HVAC232/402 display, but it can not be
edited. The monitoring values are listed in „Table 20. Monitoring values" on
page 51.
Pressing Left/Right button to change the actual parameter to the first
parameter of the next group, to browse monitor menu from V1.x to V2.1 to
V3.1 to V4.1. After entering the desired group, the monitoring values can be
browsed by pressing UP /DOWN button, as shown in „Fig. 40. Monitoring
menu display" on page 50.
In MON menu the selected signal and its value are alternateing in the dis-
play by pressing OK button.
NOTE:
Turn on drive power, arrowhead of main menu is at MON, V x.x or
monitor parameter value of Vx.x is displayed in Panel.
NOTE:
Display Vx.x or monitor parameter value of Vx.x is determined by
the last show status before power shut down. E.g., it was V4.5,
and it is also V4.5 when restart.
50