Honeywell HVAC232 Series Applications Manual page 105

1 Control signal (CS) 1 has been activated causing the output
frequency to rise. The motor runs forward.
2 CS2 has been inactivated causing the frequency to drop to 0 Hz.
3 CS1 has been activated causing the output frequency to rise again.
The motor runs forward.
4 Run enable signal is set to FALSE, which drops the frequency to 0 Hz.
The run enable signal is configured with par. 3.5.1.10
5 Start attempt with CS1 is not successful because Run enable signal
is still FALSE.
Application manual HVAC232/402 | Document 27-652 | Issue ENG06 | 2019-08-07
Table 43.
Explanations
6 CS1 has been activated and the motor accelerates (FWD) towards
the set frequency because the Run enable signal has been set to
TRUE.
7 Keypad stop button is pressed and the frequency fed to the motor
drops to 0.(This signal only works if Par.2.7 [Keypad stop button] = 1)
8 CS1 has been activated causing the output frequency to rise again.
The motor runs forward.
9 CS2 has been inactivated causing the frequency to drop to 0 Hz.
105