Connector; Short; Holder; Tensioner - Honda NSX-T 1998 Manual

Main Menu
Supplemental Restraint System (SRS)
Airbag Assembly Installation
6. Remove the short connectors from the passenger's
airbag connector and from the SRS main harness

connector.

7. Reconnect the passenger's airbag 3P connector to
the SRS main harness connector.
8. Reinstall the glove box.
SRS MAIN HARNESS
9. Remove the short connectors from the driver's air-
bag connector and from the cable reel 3P connector.
10. Reconnect the driver's airbag 3P connector to the
cable reel 3P connector. Attach the short connec-
tor to the access panel, then reinstall the panel on
the steering wheel.
DRIVER'S
AIRBAG 3P
CONNECTOR
ACCESS PANEL
Table of Contents
PASSENGER'S
AIRBAG

ASSEMBLY

SHORT

CONNECTOR
(RED)
PASSENGER'S
AIRBAG 3P
CONNECTOR
DRIVER'S
AIRBAG
ASSEMBLY
CABLE REEL 3P
CONNECTOR
SHORT CONNECTOR
(RED)
11. Remove the short connectors from the seat belt
tensioners, then attach them to their holders.
12. Reconnect the floor wire harness 3P connector to
the seat belt tensioner.
SEAT BELT

TENSIONER

3P CONNECTOR
SHORT
CONNECTOR
(RED)
CONNECTOR

HOLDER

FLOOR WIRE HARNESS
3P CONNECTOR
13. Reinstall the rear side trim panel (see
14. Reconnect the battery positive cable, then the
negative cable.
15. After installing the airbag assembly, confirm proper
system operation:
Turn the ignition switch ON (II); the instrument
panel SRS indicator light should come on for
about six seconds and then go off.
Confirm operation of horn buttons.
Confirm operation of cruise control set/resume
switch.
SEAT BELT
TENSIONER
ASSEMBLY
section 20).