Seat Belt - Honda NSX-T 1998 Manual

Main Menu Main Menu
7. Install the special tool to the SRS main harness side
of the 3P connector.
SRS MAIN HARNESS
3P CONNECTOR
8. Remove the right rear side trim panel
(see section 20).
Table of Contents Table of Contents
SRS
SERVICE
CONNECTOR
07MAZ - SP0020A
9. Remove the short connector (RED) from the short
connector holder.
SEAT BELT
TENSIONER
3P CONNECTOR
SHORT
CONNECTOR
HOLDER
SHORT
CONNECTOR
(RED)
FLOOR WIRE HARNESS 3P CONNECTOR
10. Disconnect the seat belt tensioner 3P connector,
then install the short connector (RED) to the
tensioner side of the connector.
11. Repeat steps 8, 9, and 10 on the left side.
12. After completing repair work, be sure to remove
the short connectors and reconnect all SRS
connectors.

SEAT BELT

TENSIONER
ASSEMBLY