Honda NSX-T 1998 Manual page 1502

Main Menu
Seat Belt Tensioner Removal
CAUTION:
Do not install used SRS parts from another car: use
only new SRS parts.
Carefully inspect the seat belt tensioner before install-
ing it. Do not install a tensioner that shows signs of
being dropped or improperly handled, such as dents,
cracks or deformation.
The shoulder harness anchor bolt must be removed
before you remove the tensioner.
After completing repair work, be sure to remove SRS
Service Connector.
1. Before disconnecting any part of the SRS wire
harness, install the short connectors (RED) (see page
24-10).
2. Remove the rear trim panel, upper trim panel, rear
side trim panel, and rear pillar trim panel.
REAR PILLAR
T R I M PANEL
REAR SIDE TRIM REAR TRIM
PANEL
PANEL
Table of Contents
UPPER
TRIM PANEL
3. Disconnect the 3P connector from the seat belt ten-
sioner, then install the short connectors (RED) on the
seat belt tensioners.
SHORT
CONNECTOR
4. Remove the shoulder harness anchor bolt, then
remove the two seat belt tensioner mounting bolts
and tensioner.
SEAT BELT
TENSIONER
SEAT BELT
TENSIONER
ASSEMBLY
FLOOR WIRE HARNESS
3P CONNECTOR
SHOULDER
HARNESS
ANCHOR BOLT
MOUNTING
BOLTS