Cisco Nexus 7000 Series Command Reference Manual page 53

Chapter 1 Cisco Nexus 7000 Series IP SLAs Commands
set ipv6 next-hop verify-availability
To configure the route map to verify the reachability of the tracked object, use the set ipv6 next-hop
verify-availability command. To return to the default value, use the no form of this command.
Syntax Description
next-hop-address
track
object
Command Default The NTP clock synchronization tolerance is set to 0 percent.
Command Modes
UDP jitter configuration mode (config-ip-sla-jitter)
Route-map configuration (config-route-map)
Command History Release
6.2(2)
Usage Guidelines This command does not require a license.
Examples This example shows how to configure the route map to verify the reachability of the tracked object:
switch(config-route-map)# set ipv6 next-hop verify-availability 2001:DB8:1::1
track 1
Related Commands Command
show ip sla auto group Displays the configuration including default values of IP SLAs auto-measure
OL-27555-03
set ipv6 next-hop verify-availability next-hop-address track object
no set ipv6 next-hop verify-availability
IPv6 address of the next hop to which packets will be forwarded.
(Optional) The tracking method is track.
Object number that the tracking subsystem is tracking. The acceptable range
is from 1 to 500.
Modification
This command was introduced.
Description
groups.
Cisco Nexus 7000 Series NX-OS IP Service Level Agreements (SLAs) Command Reference
set ipv6 next-hop verify-availability
1-43