Table of Contents
Advertisement
Assembly
Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this risk,
get help from other people
and use a forklift (or other
lifting equipment) rated for
weight of this machine.
To assemble jointer:
1.
Secure table locks to prevent table movement
during lifting, wrap lifting straps around infeed
and outfeed table, as illustrated in Figure 11,
then attach lifting strap ends to forklift forks,
a hoist, or other powered lifting equipment.
Figure 11. Using lifting straps to lift jointer
assembly.
2.
Lift jointer and secure to stand with (4) M8-1.25
x 40 cap screws, (4) 8mm lock washers, and
(4) 8mm flat washers (see Figure 12).
2 of 4
Figure 12. Jointer secured to stand.
Model G0656W/G0656XW (Mfd. Since 08/16)
HEAVY LIFT!
3.
Remove cabinet stand rear access panel,
then install carriage mount to jointer using (4)
pre-installed cap screws and lock washers
(see Figure 13).
Panel
Carriage
Removed
Mount
Figure 13. Carriage mount installed.
4.
Place straightedge against pulleys to check
their alignment (see Figures 14–15).
— If pulleys are aligned, go to Step 7.
— If pulleys are not aligned, do Steps 5–6.
Figure 14. Checking belt alignment.
Cutterhead
Pulley
Alignment
Motor
Pulley
Figure 15. Pulleys aligned.
2 of 4
Straightedge
-19-
Advertisement
Table of Contents
