Assembly - Grizzly G0490ZX Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble machine:
With help from another person, tip cabinet
1.
shipping box upside down, then lift shipping
box off cabinet.
Place a piece of cardboard on floor, tip cabi-
2.
net over so cabinet top is on cardboard, then
remove plastic from cabinet.
Reach inside cabinet and remove accesso-
3.
ries box, V-belt, and dust port.
Remove control panel pedestal and fasteners
4.
from inside cabinet and set aside.
Remove rear cabinet panel.
5.
Reach inside cabinet and remove (2) M8-1.25
6.
x 30 carriage bolts, 8mm hex nuts, and 8mm
flat washers that secure motor to cabinet top.
Note: Retain fasteners so they can be used
to install motor in a later step.
Using cardboard to protect cabinet, and
7.
another person to hold motor, place cabinet
on left side so dust chute is facing down.
Place motor on two motor mount brackets
8.
with pulley facing rear of cabinet, as shown
in Figure 10.
-18-
Attach motor to motor mount brackets with (4)
9.
M8-1.25 x 30 carriage bolts, 8mm flat wash-
ers, and M8-1.25 hex nuts (two sets from
inventory and two sets removed in Step 6),
as shown in Figure 10.
Note: Pulley alignment and V-belt installation
will take place in later steps.
Motor Mount Brackets
Figure 10. Motor installed.
10. Attach pedal assembly to right side of cabi-
net with (1) M8-1.25 x 50 hex bolt, 8mm
flat washer, and (2) M10-1.5 x 55 hex bolts,
10mm flat washers, and M10-1.5 hex nuts
(see Figure 11).
Figure 11. Installing pedal assembly.
Model G0490ZX (Mfd. Since 05/23)
x 4
x 2