Grizzly G0656XW Owner's Manual page 22

5. Loosen motor mount hex bolts/nuts (see
Figure 16).
Figure 16. Location of motor mount hex bolts/
nuts (3 of 4 shown).
6. Shift motor horizontally as needed to align
motor pulley with cutterhead pulley, then
tighten motor mount hex bolts/nuts.
7. Loosen motor mount bracket hex bolts/nuts
(see Figure 17). DO NOT completely remove
fasteners.
8.
Slide motor upward, place belt around
cutterhead pulley and motor pulley, then slide
motor down to rest on belt (see Figure 17).
Figure 17. Location of motor mount bracket hex
bolts/nuts (3 of 4 shown).
-20-
9. Adjust belt tension by applying downward
pressure on motor, until there is approxi-
mately ⁄ " deflection when belt is pushed with
1
4
moderate force, as shown in Figure 18.
Note: After the first 16 hours of operation,
re-tension the belt, as it will stretch and seat
during this time, which causes it to lose the
initial tension you set.
Deflection
Figure 18. Checking for proper belt tension.
10. Tighten motor bracket hex bolts/nuts (see
Figure 17), and replace rear access panel.
11. Insert cutterhead guard shaft into mounting
hole on table, then tighten set screw (see
Figure 19).
Figure 19. Cutterhead guard installed.
12. Rotate guard one revolution counter-clock-
wise as it appears from above, then have
another person hold guard in position while
you perform Steps 13–14.
Model G0656W/G0656XW (Mfd. Since 08/16)
Pulley
⁄ "
1
4
Pulley